Industry News-Shaoxing Jieteng Intelligent Drive Co., Ltd

jieteng

Home page

Jun 28,2023

Range hood push rod motor malfunction

The power line of the range hood push rod motor is in open circuit or the joint is detached. Carefully identify the open circuit or detachment point and re weld it firmly; If the on-off switch has an open circuit or poor contact, check if the circuit breaker is soldered properly. If the contact is poor, replace it with a new one;

Range hood push rod motor malfunction

Mar 25,2023

How to disassemble the range hood push rod motor

Step 1: Remove the front panel. The glass panel is an assembly of tempered glass and sheet metal parts bonded together, on which the key switch and control panel are fixed; The hook at the bottom of the glass panel and the two screws at the top are fixed with the main housing. The disassembly steps are as follows: Use a cross shaped screwdriver to remove the two screws that fix the glass panel, lift the panel upwards, and it can be separated from the shell; Then unplug the control cable connector to remove the front panel.

How to disassemble the range hood push rod motor

Oct 20,2022

Choosing an electric push rod depends on its quality first

Electric push rods are a common type of electric push rod in the natural environment of industrial production, and we are likely to see and use them less in our daily lives. So from the customer's perspective, what are the challenges that everyone must pay attention to when choosing an electric push rod?

Choosing an electric push rod depends on its quality first

Oct 20,2022

Common problems with installing and using electric push rods

The worm gear of the electric push rod has a simple structure and wears slowly during normal operation. If pre selection and post maintenance are required, some electric push rods can be used for five years or even more. Let's understand the selection of electric push rods and some issues that should be paid attention to during use.

Common problems with installing and using electric push rods

Oct 20,2022

Introduction to a series of basic knowledge about electric push rods

Electric and hydraulic push rods can be designed with different thrust according to different application loads. Generally, their thrust can reach 6000N, and the no-load operating speed is 4mm-35mm/s. The push rod uses a 24V/12V DC permanent magnet motor as the power source to convert the motor's rotational motion into linear reciprocating motion. Push a set of linkage mechanisms to complete the switching work of dampers, valves, gates, dampers, etc.

Introduction to a series of basic knowledge about electric push rods

Oct 20,2022

Detailed explanation of the performance of electric push rods

1、 Because the electric push rod varies across the entire load, the safety factor also needs to be correspondingly amplified. Therefore, the larger the load, the greater the safety factor selection. 2、 Due to the fact that the electric push rod mainly adopts adjustable stroke control in the mechanism, the stroke of the push rod can be controlled, and the full stroke and any stroke can be freely controlled.

Detailed explanation of the performance of electric push rods

< 1 2 >

Jieteng

Telephone

/ TEL

Mailbox

/ EMAIL

457634096@qq.com

Address

/ ADD

89 Putian Avenue, Pukou Street, Shengzhou District, Shaoxing City, Zhejiang Province

Message

/MESSAGE

Copyright©Shaoxing Jieteng Intelligent Drive Co., Ltd